Care

1. Pull out the insoles and laces

Before cleaning the shoes itself, it is advisable to remove the laces so that you can also properly clean the folds around the tongue. Remove the insoles and let them dry. You can wash the insoles by hand in soapy water. Water temperature max. 30ºC and do not dry them on a direct heat source.

2. Clean the sole

Remove coarse dirt and stones from the sole. Then clean the sole including the rubber protectors with a brush in warm water.

3. Clean the upper

Clean dust and dirt from the upper with the Power Cleaner Set foam, which gently and gently removes dirt, water and salt stains while nourishing the material. If you don't have cleaning foam available, clean the upper of the shoes in warm water with a soft brush or cloth. You can also rinse shoes with a Gore-tex membrane inside the shoes.

4. Let the shoes dry

Allow the shoes to dry freely. Please never dry leather shoes in direct sunlight or near a direct heat source. When drying, it is advisable to put a shoe stretcher inside the shoes, or newspapers will also work well.

5. Treat the leather

After drying, you can nourish the leather with Velour Nubuck Care emulsion. Shake thoroughly before use and apply evenly to the surface with a sponge. Allow to dry sufficiently again. Then brush the surface of the leather with a nubuck rubber brush. 

6. Impregnate

Apply impregnation to shoes that are not yet completely dry. Velour Nubuck Care spray or Nano Protect spray, which is suitable for all types of leather and textiles, will serve you well for this. Spray in at least three layers so that the product does not run over the surface of the skin and so that the individual sprays do not dry out. We recommend impregnation outdoors or in a well-ventilated room.

We recommend using shoes up to 24 hours after treatment